Environmental
Primeco,
Inc.
Location: United
States
Description:
Engineering design and CADD drafting
services for an environmental program
associated with various property improvement projects at approximately
70 store locations in
10 states. Typical environmental related work includes: the
oil/water separation system; the
wash area reclaim system; disposal procedures for used oil
filters, used oil, and other
hydrocarbon waste products; preparation of a standard store
operations manual for
environmental compliant housekeeping practices; regulatory
assessment and recommended
management program for on-site storage of hydrocarbon products;
and, preparation and
acquisition of air emissions permits associated with the on-site
sand blasting and painting
of rental equipment.
Preparation of a comprehensive survey of the federal and state
regulations, national and
state fire codes and various industry standards that effect
the installation and operation of
underground and aboveground motor fuel storage tanks in 10
states.
Preparation of a complete underground storage tank (UST) management
program including
design, operations and maintenance to meet current regulations.
Contributed to a client policy manual for implementation of
the state and federal underground
storage tank regulation requirements for release detection.
Prepared the spill control and containment system design philosophy
which defined the
various spill control areas of the client's facilities and
the design considerations at each.
Preparation of client procedures associated with the operation
and maintenance of the
completed property improvements including the equipment wash
and the hydrocarbon
storage tank areas.
Exxon
Company, International
Location: Worldwide
Description:
Development and presentation of a pollution
control training program module
for first line supervisors at marketing petroleum product
terminals. Primary focus of the
program covered the control of air and water pollution. The
primary potential for release of
hydrocarbon vapors to the atmosphere is at the storage tank
farm and at the tank truck loading facility. The control of
oil pollution involved the separation and individual management
of permanent oil bearing flows, intermittent oil bearing flows,
and oil free flows to eliminate
potential contamination of the environment.
 |
Northwest Airlines, Inc.
Location: Michigan
Description:
Design and CADD drafting services for
the permit acquisition, construction
documents and on-site inspection for the tie-in to an existing
sanitary sewer system from an
existing oil/water separator. In addition, storm water collected
in the Jet A tank farm is to be
routed to state waters through an "oil-stop" system.
EMANCO,
Inc.
Location: Arizona
Description:
Technical review and comment on state
issued construction stipulations for
pipeline hydrostatic test water discharge for the planned
Enron-Transwestern Pipeline
expansion.
Patrick
D. Mahoney, P.C.
Location: Texas
Description:
Management and client representative
services for the removal of a motor fuel
underground storage tank and site clean up. Technical assistance
was also provided in the
preparation and filing of the tank removal and disposal report
with the Texas Water Commission.
Department of Veterans Affairs
Location: Texas
Description:
Technical coordination, witnessing and
certification of the annual tightness
integrity tests for gasoline and diesel underground storage
tanks per EPA and NFPA criteria.
Gulf Resources Corporation
Location: Texas
Description:
Preparation of Form PI-7, submission
and permit acquisition from the Texas Air
Control Board for the Solano Amine Unit.
|
